Echelon LonPoint Module Manual de usuario descargar pdf (Pagina 95)

9-2 Installing the AO-10 Analog Output

Module

LonPoint AO-10 Analog Output Module

The front panel of the AO-10 module is shown in figure 9.1. There are no

front panel LEDs associated with the outputs, however, there are user-

configured jumper blocks that must be set correctly for each analog output.

™

Network Access Jack; Use

With Echelon PCC-10 Cable

Model 78303

Peel-Off Code 39

Format Bar Code of

LonPoint Interface

Neuron Chip ID

Number

LonPoint Interface

Model and Software

Revision Numbers

Service LED

Service Switch

Power/Wink LED:

Power ON: Illuminated Continuously

Wink: Flashing

Analog Output 1

Analog Output 2

Analog Output Identifier

(No LEDs For Analog Outputs)

AO-10

MODEL 41400 9760

SW VERSION 3.0

ID NUMBER

OUTPUT: 1012VDC, 0-20mA EACH

LISTED 178K

ENERGY MANAGEMENT

EQUIPMENT SUBASSEMBLY

AO-10 MODEL 41400 ID NUMBER

Figure 9.1 LonPoint AO-10 Analog Input Module - Front Panel

The AO-10 module includes two 4 x 2 jumper blocks for each output. These jumper

blocks, labeled 0-10V and 4-20mA, are used to configure the module for the type of

analog output signal that will be generated (figure 9.2); using an incorrect jumper

setting will result in improper output signals. Each of the two outputs may be

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 114 115

Sin comentarios

Echelon LonPoint Module Manual de usuario Pagina 95