Echelon DM-21 Device Manager Manual de usuario descargar pdf (Pagina 66)

5-14 Installing and Getting Started with the Device Manager Software

The drawing should look like figure 5.12.

Figure 5.12 – LonMaker Network Drawing for Example 2

9. Use the Loading Wizard to load the database into a Device Manager

(following steps 8 to 18 in Example 1, earlier in this chapter).

10. Physically install the LonPoint DI-10 and DO-10 modules.

11. Using the demonstration location string setting tool available on the Echelon

web-site (http://www.echelon.com/products/dm), or an equivalent tool, set the

location strings of both DO-10 modules.

12. Attach the Device Manager to the network. The Device Manager will find the

DI-10 and both DO-10 modules, query the locations of the DO-10 modules

and commission the network.

• Unlike Example 1, Example 2 contains two devices of the same type, namely

the two LonPoint DO-10 modules. To differentiate between the two DO-10

modules, the Device Manager relies upon the location string present in the

DO-10 module to match the location string specified in the drawing.

• An example of such a tool that sets individual location strings and runs on a

PC is available at http://www.echelon.com/products/dm.

Multi Subsystem Network Using a Single Device Manager

(Example 3)

This example consists of 4 subsystems each with varying numbers of devices and

builds on the photocopier example described in Chapter 1.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 105 106

Sin comentarios

Echelon DM-21 Device Manager Manual de usuario Pagina 66