Echelon Lumewave CPD 3000 Lighting Controller Manual de usuario descargar pdf (Pagina 11)

CPD 3000 Integration Guide 11

Table 1 LC Network UNVTfaults Variables Implemented on the CPD 3000

Network Variable Type Notes

nviLampValue

SNVT_switch

Primary control input. The level

translates to a 0-10V control signal with

the transform being subject to the values

configure in nciControlConfig defined

below. By default, 50% results in a 5V

control signal to the ballast, driver, or,

generator controlled by the CPD 3000.

nviStatReset UNVTstatControl

Sets/initializes energy, runtime, and

error counts.

nvoControlData UNVTcontrolData

A structured variable describing all

current operating values and state of

the LC. This is described in the

following section.

nvoLampFb SNVT_switch

Feedback of the current

nviLampValue. In normal operating

conditions, this value will reflect the

nviLampValue. It may differ if the

heartbeat interval is exceeded and the

defaultLevel differs from the value

in nviLampValue.

nvoLcStatus UNVTfaults

Feeds alarm logs only on change to

minimize the data requirement on the

IP network. The frequency of changes

to this variable is carefully managed

to conserve bytes consumed by data

logs.

nvoVersion UNVTversion

A string describing the version of the

OLC application, such as 1.00.09.

UNVTcontrolData – nvoControlData Details

The LC conserves power line bandwidth by reporting the operating state of the

LC in a single output network variable nvoControlData (UNVTcontrolData),

described in this section. Previous profile designs typically require three poll

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 22 23

Sin comentarios

Echelon Lumewave CPD 3000 Lighting Controller Manual de usuario Pagina 11